Sticky key keyboard cleaner spray install#
Install the rest of the keys by aligning and firmly pressing down.However, most keys can be removed by using a plastic wedge such as a trim removal tool or a small flathead screwdriver. Firmly press down to snap the key into place. Place ends of wire in the guide slots adjacent to the key location when aligning the key. Make sure wire is secured in the key, usually snapped into place. Place all rubber components into the keyboard. The machine now has perfectly cleaned and lubricated keys and rubber components for the keyboard. Apply lubricant (as above in LUBRICATE KEYS) to the keyboard and let dry. Mask off the ZPC-GX31 with paper and scotch tape. DO NOT overdue this step as the carrier solvent may affect the plastic. Do this from all 4 sides to assure penetration and coverage into the small and critical guide spaces inside each key. Lightly coat the keys, at a 45 degree angle with Super Lube Dry Film lubricant.
Fold the towels over and press to squeeze most of the water out of the pieces. Rinse these thoroughly with hot water and place on paper towels. Use stopper in the sink so that none are inadvertently lost. Spray with household cleaner and let stand for 5 minutes. Place all rubber components in a kitchen strainer. Rinse thoroughly with hot water and place keys on paper towels to dry. Some keys have wires attached and some grease on them, clean these first with cotton swabs and lighter fluid. This action will remove any petroleum based contaminants as well as the grease that is sometimes used on the wider keys which may have guide wires. Even the smallest key guides can be cleaned with small pieces of foam rubber and tweezers. Repeat this procedure again using rubbing alcohol and cotton swabs but NOT the foam rubber as it disintegrates when used with alcohol.įinally repeat this procedure using lighter fluid and foam rubber. Each and every key space must be cleaned inside and out this is critical since this is where the key touches and moves. For the very small places, cut the foam rubber into small pieces and use the tweezers, again SLIGHTLY DAMPENED, for cleaning. This will clean all water soluble contaminants like soda, coffee, and sugar residue. If they are too wet the excess water will contaminate the keyboard through capillary action. Replace these often and BE SURE they are only slightly damp. CAREFUL, these are small and like to jump away.Ĭlean the keyboard with cotton swabs SLIGHTLY DAMPENED with water. Remove all of these and place in a separate container. There will be a small rubber piece for each key.
IMPORTANT: Make a keyboard map so as to remember where each key goes.Ĭarefully pry each key loose with a small screwdriver and place in a container.
Super Lube Dry Film spray (critical - DO NOT SUBSTITUTE!) available in the automotive section.Household cleaner, Windex or equivalent.Cosmetic foam rubber cleaning pads (use only with lighter fluid, NOT alcohol).This will require about 2 hours time once the proper cleaning materials are collected. The following will completely solve these problems and return the keyboard to perfect operation. There are several reasons why the keys will start to stick - spilled drinks, wearing off of factory lubrication, weakening of the rubber pieces which give each key its snap action, and contamination by dust and hair. Proper cleaning and lubrication as described here will restore a ZPC-GX31 keyboard to the snappy and smooth performance it had when new. This process will restore a ZPC-GX31 keyboard to like new performance. Trying anything suggested here or anywhere on the web is always at one's own risk. It is provided as a courtesy, and no warranty is expressed or implied. Do NOT follow this procedure for the ZPC-D5. The following information is recommended for advanced users only, and ONLY APPLIES TO THE FOLLOWING CYBERNET MODELS: ZPC-9000, ZPC-9100 and ZPC-GX31. Cause - Keys have become soiled/dirty over time, causing them to stick and/or not snap back properly
0 kommentar(er)
